Autolevel Failing

1) First, make sure to give a deep clean to the nozzle and the 4-bed corners, use isopropyl alcohol.

Nozzle

Bed corners

2) Extrude the filament for at least 2-3 inches to flush out impurities.

Go to Menu >> Change filament>> 220 ℃ (for PETG)>> Continuous under LOAD

3) If it is failing on a particular corner, use a hex key to slightly unscrew the center of the corner so it’s loose. Then rotate it clockwise slightly and screw it back down so it’s tight again.

4) If it seems to be getting caught on the white wiper pad, remove the pad entirely and just be sure to clean the nozzle well.

Here are the steps for removing the wiper pad

Unscrew the back and front set of screws

Remove the wiper pad from the mount.

Updated on: 11/11/2024

Was this article helpful?

Thank you!