Copoly Plate Maintenance
Copoly Plate Maintenance
The Copoly plate will need to be cleaned to help ensure that filament is properly laid down and is secured on the surface.
Here is what a new vs clean vs dirty Copoly plate will look like:
Brand new plate
Dirty plate
What you will need:
- Isopropyl alcohol (IPA) (90% or higher)
- Paper towels
- Scraper
- BuildTak Bond
Instructions:
1.) Pour IPA onto BuildTak plate and let sit for 2-5 minutes.
2.) Scrub with paper towel and if needed, gently scrape filament residue with a scraper. Then wipe off with a dry paper towel.
3.) Repeat steps 1 and 2 until clean.
4.) Let plate air dry or wipe IPA off thoroughly with paper towel(s) and then put back on the printer’s magnetic bed.
5) Apply BuildTak Bond.
6.) Increase the bed temperature to 50℃.
On the printer screen:
7.) Wait 5 to 10 minutes to allow the BuildTak bond to dry. (It’s a good time to grab that cup of coffee you been waiting for all day.)
8.) Once BuildTak Bond is dried, you’re ready for your next print!
Updated on: 20/11/2024
Thank you!