Articles on: Products & Placing Orders

Galileo Guards

Table of Contents
Sizing Guidelines
Print a Galileo Guard
Post-Processing Requirements

Sizing Guidelines


Galileo Guards come in sizes S - XL. See the following chart for sizing specifications.

Sizing Guidelines

Print a Galileo Guard on Your Galileo Printer



Log into FabOne and navigate to Galileo > Print Control. Then, click on the "Off-The-Shelf" section to see your ready-to-go print options.
Click on your desired Galileo Guard size, and click "Confirm for Printing" to start the print.

Be sure you have loaded the Cheetah TPU filament. No other filament will work with these files.

Start a Print in FabOne

Post-Processing Requirements


The guard prints with a section that needs to be removed after printing. See the section outlined in blue below. It will be printed as a depressed area, so you will clearly see where to cut with scissors.

You can use any material you'd like for the straps (velcro, dacron, etc.). Play around with what works best!

Blue lines indicate where to cut
Use scissors to cut out the depressed section

Updated on: 06/12/2024

Was this article helpful?

Share your feedback

Cancel

Thank you!