Articles on: Filament FAQ

Printing with CPX

Printing with CPX


For Help with Loading the CPX, Please see our filament loading guide


When swapping to the Copoly Printing bed, you may need to raise the Z-Offset to compensate for the thicker bed. Be sure to note your original Z-Offset before you change it.


Prep Copoly Plate with BuildTak Bond


  1. Check that two silver tabs of the Copoly plate are in the back


  1. Apply BuildTak Bond on cold Copoly plate.


  1. Heat bed to 50C and let dry. You can select Preheat on the main screen to heat the bed to 60C, which is fine.


  1. After the Bond dries, you are ready to start printing. Feel free to start your first Copoly print and let us know how it goes!


The layer of BulidTak Bond will last several prints before having to be cleaned and reapplied.


Before


After


Removing Copoly from the Print Bed


  1. After a print has been completed, you'll need to reheat the bed to 50°C to remove the print.


You can select Preheat again on the main screen to heat the bed to 60C, which is fine.


  1. Using the scraper, carefully peel the print from the bed, being sure not to use too much pressure.


Be Careful, the Bed is HotUsing too much pressure with the scraper will remove the applied Bond and the special coating on the Copoly Bed. Use just enough to move the carefully print.

Updated on: 05/06/2025

Was this article helpful?

Share your feedback

Cancel

Thank you!