Galileo
  • English
Go to website
Back
Articles on:Hardware Maintenance
Keep your printer in tip-top condition by performing regular maintenance.

Categories

  • My Account
  • Protosthetics Scanning App
  • Getting Started with Galileo
  • Products & Design Options
  • Managing FabOne Orders
  • Filament FAQ
  • Starting Prints
  • Hardware Maintenance
  • Troubleshooting
  • Printer Preschool
  • Returning a Printer
    Returning a Printer Required Tools: 2.5mm hex key 4mm hex key Adjustable wrench Packaging tape Camera (for taking a few photos) Impact drill with a 7 mm hex socket attachment to remove mounts (for new cabinets version 1.10 -1.15) Printer Box 2 large pieces of foam (top and bottom) 3 small pieces of foam (piece A, B, C) 2 cardboard (top and bottom pieces)Few readers
  • Using 3D Clean Sticks
    3D Clean Sticks - Loading and Usage The 3D Clean Sticks should be used when changing to a different filament. You don't need to use the Clean Sticks when swapping to another roll of the same filament. You only need to use half a stick of 3D Clean per filament swap so every full stick is 2 filament changes. Full and Half Stick of 3D Clean Steps for Usage Heat the tool head to 270°C and unlFew readers
  • Cleaning the Asteroid Toolhead
    Cleaning the Asteroid Toolhead Before we get started, you'll need the following supplies: A 2mm Hex Key - located in the Kiosk Drawer, see the green pouch A Red Scrub Pad A pair of needle nose pliers Needed Parts Step 1: Removing and cleaning the Heat Shield Start by heating the toolhead to 220°C and wait for the nozzle to heat up. Use the Change Filament Screen Using theFew readers
  • 2.4mm Nozzle BLTouch Spacer Installation
    2.4mm Nozzle BLTouch Spacer Installation In this document we will install the essential 2.4mm nozzle spacer. This spacer can be used without interfering with the operation of the standard nozzle. Removing the BLTouch Using a 2mm hex key, undo the two bolts securing the BLTouch unit, while still keeping them in the BLTouch bracket. Installing the Spacer Drop the spacer onto the two bolts.Few readers
  • Replacing the Surface of a BuildTak Copoly Bed
    Replacing the Surface of a BuildTak Copoly Bed If the surface of your copoly bed is damaged in some way, it will need to be replaced entirely. Some examples of a damaged surface include when it is chipping or bubbling up severely. Black Surface is Chipping Black Surface is BubblingFew readers
  • Kiosk Monthly Maintenance Checklist
    Kiosk Monthly Maintenance Checklist Proper kiosk and 3D printer maintenance is essential for keeping your machine running and performing at its most optimal level. It is highly recommended to complete this checklist every month. See below to find out what's required and why. Deep Clean the Build Plate Remove any large pieces of plastic by hand/with the scraper. Pour 90% or 99.9% isopropyl alcohol on to a paper towel. Wipe/Scrub the plate until clean. Why this is important? AlFew readers

Not finding what you are looking for?

Chat with us or send us an email.

  • Chat with us
  • Send us an email
© 2025 GalileoWe run on Crisp Knowledge.